By placing the slats along the wall, she created gaps just big enough for petite shoe shelves even Carrie Bradshaw would covet. “If something doesn’t function well, it has no purpose.” Inspired by the slat wall trend and sliding shelf project, she cooked up her own closet creation- see the step-by-step process in her Instagram stories. “Functionality is at the core of every design decision I make,” she says. When Phoenix interior designer Kera Jeffers wanted to give her walk-in closet a makeover, she knew that tidying up the shoes was a must. “I would use finish nails or brads without a head that can be countersunk and then filled in with wood glue or filler,” Davis says.

Place a small dollop of glue to the back of the slat, then attach to the cabinet. Use wood glue and a nail gun to attach the slats. You can have them trimmed for you on-site at a home improvement store. For a tambour effect-which works great in a small space-allow the slats to touch, Davis says.Ĭut the half-round strips of molding to the length of the surface you want to cover (or the width for horizontal slats). You can take a photo, print it out, and draw the slats over top. To figure out the slat spacing and number of strips to buy, measure the cabinets. 3/8-by-2 1/4-inch-by-7-foot half-round strips of ornamental molding (flat molding can work too).Small created her own custom stain color by applying Minwax Driftwood first and then the Varathane Early American finish.įor wood-slat screens for slab-front cabinets you’ll need: Test the stain on both the wood legs and the veneer finish as the two materials may absorb the color differently. Use wood glue and finishing nails to secure all of the leg/frame pieces.Īs Small applied the veneer, she temporarily used PVC pipes underneath, slowly smoothing out the veneer from one end to the other, and thus preventing air bubbles.ĭeciding on the color of wood stain, Small used a mid-tone color to reflect the red oak finish. Repeat the process to make the second supporting piece. Leave about 1/2 inch (or the width of your plyboard) at the top so that the shelf fits in smoothly. The last piece will go 12 inches above the center, and will serve as a marker for the top. The middle rung will go 16 inches above the bottom. Take two 36-inch long pieces and secure a short piece of wood (this will determine the width of your console) about 5 inches from the ground-this is the bottom. To create the legs, which serve as the frame, cut the wood boards into four equal 36-inch pieces. Apply the edge banding to the front and veneer to the top. You will need a jigsaw to create the curve. Cut three shelves from the plywood to the desired shape and size.

Diy wood shop slot wall